SMPS Battery Charger
Function
Switching Mode Control based Design
Charges batteries with CC/ CV mode.
Over Voltage & Over Current protection.
User Friendly Operation.
Input Surge current limiting.
Low Ripple & Noise.
Over Temperature Shutdown.
LED indication for
Mains(Green),Float(Green),Boost (Yellow) and Battery Rev. (Red).
Potential free contact for fault indication. Compact, detachable connector and panel mountable
[wpdm_package id=’5999′]
Description
Baid Power Services P. Ltd. (BPS) makes different type of Switched Mode Power Supply (SMPS Power Supply). BPS Make SMPS Battery Charger- are made suit different battery voltage and different capacity. These are compact, reliable and cost effective solutions for charging different types of batteries.
BCS1210SR3 is designed for charging 12 Volt battery @ max 10 Amps.
It is compact ( 190 mm x 65 mm x 121 mm) and panel mountable. It has detachable connector for easy wiring and replacement. It has input AC voltage range is 170-270 Volt and DC Output is 13.5-14.5 V for charging 12 V. battery. The charger has auto Boost/ Float selection. If connected battery draws current over 1 Amp, it start the battery with Boost mode till the battery reach 14.5 V. After reaching 14.5 V. it will be shifted to Float mode with 13.5 V thus keeping battery under Float mode. It has protection for overload, Battery Reverse connection & Over Temperature protection.
It is most suitable for electrical panels with DC source like AMF panels and for automotive battery.
For different applications and different voltage and current rating, please mail your requirement.
BCS1210SR3 is designed for charging 12 Volt battery @ max 10 Amps.
It is compact ( 190 mm x 65 mm x 121 mm) and panel mountable. It has detachable connector for easy wiring and replacement. It has input AC voltage range is 170-270 Volt and DC Output is 13.5-14.5 V for charging 12 V. battery. The charger has auto Boost/ Float selection. If connected battery draws current over 1 Amp, it start the battery with Boost mode till the battery reach 14.5 V. After reaching 14.5 V. it will be shifted to Float mode with 13.5 V thus keeping battery under Float mode. It has protection for overload, Battery Reverse connection & Over Temperature protection.
It is most suitable for electrical panels with DC source like AMF panels and for automotive battery.
For different applications and different voltage and current rating, please mail your requirement.
Specification:
| AC Input | : 170-270V AC |
| DC Output | : 3 Phase 4 wire |
| -Float Mode | : 13.5 V |
| -Boost Mode | : 14.5 V |
| Charging current | : 10 Amps (max.) |
| Withstand Voltage | : I/P-O/P-3kV |
| Line Regulation | : +/- 2% on full load |
| Load Regulation | : On main of +/- 2% |
| Working Temperature | : 10~60 Deg C |
| Efficiency | : >85% typical @ full rated load |